A
complete system of diamonds, mounted stones, rubber wheels and
discs designed specifically for sintered Zirconia
For
both Technicians and Dentists
Sintered Zirconia is extremely sensitive
to heat--and the use of improper instruments either in the Laboratory
or Operatory may cause checking or cracking of the sintered zirconia
at a later date--and a costly failure of the restoration. A
polished surface also provides a higher biaxial flexural strength.
Only the Zircoline System provides
a complete assortment of specifically designed instruments to avoid
overheating the sintered zirconia along with an easy technique for
adjusting, correcting, polishing, finishing, separating, and milling
of sintered zirconia.
The
shapes are specifically designed for working with zirconia
in either the Laboratory or Operatory--not just modified
diamonds.
The
4 grits are specifically designed for sintered zirconia,
along with other extremely hard materials, providing for
very accurate reduction.
The
unique production process and materials utilized makes these
diamonds very long lasting and cost effective.
The
longer shanks are made in a special stronger material to
eliminate breakage or bending--while allowing for
improved operator access and visibility.
A special
thin Disc is available for cutting of sprues and interproximal
adjusting.
Run at 160,000 rpm with
Water Coolant
Longer
shafts provide for improved operator access and visibility.
A special thin Disc is available
for cutting of sprues and interproximal adjusting.
Diamond
Mounted Stones
Very
unique combination of ceramic binder and high quality diamonds
to provide cool cutting or polishing at a slower speed without
a water spray coolant.
Two
Grits are ideal for final finishing under microscope at
slower speeds.
Ideal
for the laboratory that does not have a high speed air rotor
with water coolant.
Rubber
Wheels and Points
These
are made of a special latex-free synthetic rubber binder
and filled with three grades of high density pure diamond
particles.
Excellent
for low heat generation final trimming, polishing, and high
shine of zirconia or other hard ceramics.
The
Blue are ideal for final trimming and adjustment while eliminating
the fine scratches, fissures, or cracks that may lead to
fracture or breakage.
The
Pink and Grey polishers provide a low heat smooth high luster
finish.
Zirconia
Milling
Using the Zircoline Diamonds mounted in
a milling machine or an adaptor on a surveyor.
The Hydro-Air
Carver is a versatile, compact unit, with a lightweight handpiece
for precise shaping of hard and very hard materials.
The spray can be switched on and off quickly
with the switch on the handpiece. This unique feature
reacts instantly and avoids "over-flooding" the workspace
and workplace. Fine adjustment of the spray is achieved
by using the air and water regulators at the front of the unit.
The spray traps the dust, protects the grinding tools, and prolongs
their life. The spray prevents overheating of the material
being worked on and therefore minimizes the risk of fracture
and discoloration.
The extra slim design of the rotor gives
maximum working comfort and maximum visibility to the piece
being worked on. Lubrication is applied directly to the
rotor's ball bearings. This other unique feature increases
the lifespan of the motor considerable.
Burs are changed without the need of a tool.
In addition, our handpiece can be fitted with any pneumatic
instrument connecting to a Midwest (4 hole) standard.
The
Hydro Air Carver:
*Base Unit with filter, pressure
regulator, manometer, water container and spray regulators.
*On / off foot control
*Handpiece with rotor
Technical
Data
Speed: 300000 rpm
Operated by: compressed air
Operating Pressure: 2.8--3.2bar
Air consumption: 40 Vmin.
Water Tank: 350 ml
Chuck Diameter: 1.6mm
Lubrication: manual
(special lubricant is provided)
