|
Preat Perma Fiber for new
dentures
1 |
Prepare a recess for the fiber reinforcement
(FIG 1). |
Run a length of wax wire along the recess prepared (FIG
2). This will provide an accurate
measuring medium for both the length (FIG
3) and shape of the Fiber. Place this wire in a
putty mold (FIG 4).
5 |
6 |
Placing the wax wire in the putty mold will create a
recess (FIG 5). Remove the wax wire
(FIG 6).
7 |
8 |
Enlarge the original recess in the putty mold
(FIG 7). Use the wax
wire to measure the length of Fiber needed (FIG
8).
9 |
10 |
Place the fiber into the recess in the putty mold
(FIG 9).
Wet the fibers with a low viscosity mixture of cold curing acrylic,
and place
the fiber in a pressure pot (FIG
10).
11 |
12 |
Refine and roughen the surface of the Fiber reinforcement by grinding
(FIG 11). Do not
polish, as a rough surface will allow a better bond with the heat curing
acrylic. Wet the surface of the reinforcement with monomer liquid before
installing it into flask. The monomer liquid is used to wet the surface of
the dentures area to achieve better bonding to added acrylics.
Trial pack with plastic foil. The trial pack is done WITHOUT the reinforcement
(FIG 12).
13 |
14 |
Open the
flask and place the pre-shaped, roughened, and monomer wetted reinforcement in place
(FIG 13).
Check
to ensure the Fiber is properly in the denture. Add extra acrylic
resin (FIG 14).
15 |
Final pack and cure of the Stick Fiber reinforced denture
(FIG 15). |
Back to Fiber and Mesh main page
|
PREAT Perma Fiber & Mesh is a
product of |
|
|
T0054.REV.00
|
